Checkmate – step 3

The third step in making a pepper mill sounds like a simple one… just drill the holes.   People drill holes all the time and it just takes a few seconds right?  These holes, however, take a little more care and attention.   These specific peppermill styles require 4 different drill sizes, they need each to be drilled to specific depths, and you want them to be dead centered.

In order to drill the holes I opt for a rig that involves a tool called a steady rest (see picture).  This allows me to support the far end of the pepper mill while drilling.   Some may consider this over kill, but I find that the additional support helps to keep the drill bit centered by eliminating wobble at the far end.  A shorter peppermill (4-6″ tall) is usually not a problem, but a taller one (they go as high as 24″!) will generate more wobble.  The steady rest also keeps things from becoming air borne if an accident should happen.  Once drilling begins, care needs to be taken so that the bit doesn’t over heat and burn the wood or wander off-center and drill crooked.  The only way to do this is with time – slow and steady wins the race here.  Drill slowly and clear out the wood chips as you go.

Soon you will be all done and you’ll be on to shaping the outside.  That is where all the fun is and it won’t be long now!

Thanks for following along!

-Derek

http://handmadewoodgifts.com

http://www.etsy.com/shop/HandMadeWoodGifts

http://www.facebook.com/pages/HandmadeWoodGifts/202991473994

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: